ENWW
Using the Embedded Web Server 129
Link settings
(For wired 10/100TX networks only) Set the network link
speed(10 or 100 Mbps) and communication mode (full- or
half-duplex) for HP Jetdirect 10/100TX print servers. The
available settings are listed below.
CAUTION
: If you change the link setting, network
communications with the print server and network device may
be lost.
●
AUTO: (Default) The print server uses autonegotiation to
match the network’s link speed and communication mode. If
autonegotiation fails, 100TXHALF is set.
●
10TXFULL: 10 Mbps, full-duplex operation
●
10TXHALF: 10 Mbps, half-duplex operation
●
100TXFULL: 100 Mbps, full-duplex operation
●
100TXHALF: 100 Mbps, half-duplex operation
DNS Server
Specify the IP address of the DNS (Domain Name System)
server.
Email (SMTP)
Server
Specify the IP address of the preferred outgoing e-mail Simple
Mail Transport Protocol (SMTP) server, for use with supported
Scan devices.
Scan Idle Timeout
Specifies the number of seconds that an idle connection for
scanning is allowed to remain open. The maximum is 3600, and
the default is 300. If set to 0, the timeout is disabled and the
connection will remain open until closed by the network system
that is accessing the device.
Locally
Administered
Address
Specifies a locally administered address (LAA) that replaces the
factory-assigned LAN Hardware (MAC) address. If LAA is used,
a user-specified string of exactly 12 hexadecimal digits must be
entered.
For Token Ring print servers, the LAA address must start with
hexadecimal 40 through 7F.
For Ethernet print servers, the LAA address must start with
hexadecimal X2, X6, XA, or XE, where X is any hexadecimal digit
0 through F.
The default address is the factory assigned address.
Table 4.8
Miscellaneous Settings (2 of 5)
Item
Description
