ENWW
TCP/IP Configuration 82
sys-location
Alpha-numeric string (up to 255 characters), typically used
to identify a location.
sys-contact
Alpha-numeric string (up to 255 characters), typically used
to identify the name of a network or device administrator.
ssl-state
Sets the print server’s security level for Web
communications:
1 (default): Forced redirection to the HTTPS port. Only
HTTPS (secure HTTP) communications can be used.
2: Disable forced redirection to HTTPS. Both HTTP and
HTTPS communications can be used.
security-reset
Reset security settings on the print server to factory default
values. 0 (default) does not reset, 1 resets the security
settings.
Wireless 802.11Main Settings
Command
Description
network-type
Specify the 802.11 wireless network topology:
Infrastructure
: The print server will communicate on the
network with other wired or wireless devices through an
Access Point.
Ad Hoc
: (default) The print server will communicate with
other wireless devices directly, without using an Access
Point.
desired-ssid
Specify the desired Service Set Identifier (SSID), or Network
Name, for the print server. Up to 32 alphanumeric characters
may be used.
The factory-default SSID is
hpsetup
in Ad Hoc mode. An
Infrastructure network SSID of
hpsetup
should not be
used.
If the ssid command is issued without an entry (a blank
SSID), the desired SSID will be assigned <AUTO>, where
it will associate with the first network that matches its
authentication settings.
encryption
Specify the use of encryption. 0 (default) disables, 1
enables.
wep-key-method
Specify the format for WEP key entry. WEP key entries must
be of the proper length.
ASCII
: (default) Use alphanumeric ASCII characters (0 - 9,
a - z, A - Z). For 40/64-bit encryption, enter 5 characters. For
104/128-bit encryption, enter 13 characters. ASCII entries
are case-sensitive.
HEX
: Use hexadecimal digits (0 - 9, a - f, A - F). For 40/64-bit
encryption, enter10 hexadecimal digits. For 104/128-bit
encryption, enter 26 hexadecimal digits. HEX entries are not
case-sensitive.
Table 3.4
Telnet Commands and Parameters (2 of 18)
