Removing or installing a Fibre Channel interconnect blank
Before you begin
CAUTION:
•
Before removing a component or blanking panel from an operational device, make sure that you
have the replacement part available. Removing a component or blank impacts the air
fl
ow and
cooling ability of the device. To avoid possible overheating, insert the new or replacement component
within one or two minutes. If the internal temperature exceeds acceptable limits, the device may
overheat and automatically shut down or restart.
•
Parts can be damaged by electrostatic discharge. Use proper anti-static protection.
Removing an interconnect blank
1.
Loosen the thumbscrew that holds the blank in place
(1
).
2.
Remove the blank from the back of the unit (
2
).
2
1
15568
Installing an interconnect blank
Place the blank into the MSA chassis bay and tighten the thumbscrew that holds the panel in place.
maintenance and service guide
71
Summary of Contents for 201723-B21 - HP StorageWorks Modular SAN Array 1000 Hard Drive
