Hard drive
NOTE:
The hard drive spare part kit does not include the hard drive bracket, hard drive connector
cable, and screws. These components are included in the Hard Drive Hardware Kit, spare part
number 731424-001.
Description
Spare part number
500 GB, 5400 rpm, 7.0 mm, for use on all computer models
683802-001
320 GB, 5400 rpm, 7.0 mm, for use only on HP Pavilion TouchSmart 11 Notebook, HP Pavilion
11 Notebook, or HP 215 G1 Notebook PC computer models
645193-001
Before removing the hard drive, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the battery (see
Battery on page 40
).
5.
Remove the service door (see
Service door on page 41
).
Remove the hard drive:
1.
Disconnect the hard drive connector cable
(1)
from the system board.
2.
Release the hard drive connector cable from the routing channel
(2)
built into the base
enclosure.
3.
Remove the four Phillips PM2.0×2.75 screws
(3)
that secure the hard drive to the computer.
42
Chapter 5 Removal and replacement procedures for Customer Self-Repair parts
Summary of Contents for 210 G1
Page 4: ...iv Important Notice about Customer Self Repair Parts ...
Page 6: ...vi Safety warning notice ...
Page 10: ...x ...
