Memory module
Description
Spare part number
8 GB (PC3L, 12800, 1600 MHz), for use with all computer models
693374-001
4 GB (PC3L, 12800, 1600 MHz), for use with all computer models
691740-001
2 GB (PC3L, 12800, 1600 MHz), for use with HP 210 G1 computer models only
691739-001
Update BIOS before adding memory modules
Before adding new memory, make sure you update the computer to the latest BIOS.
CAUTION:
Failure to update the computer to the latest BIOS prior to installing new memory may
result in various system problems.
To update BIOS, refer to
Updating the BIOS on page 77
.
Before removing a memory module, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the battery (see
Battery on page 40
).
5.
Remove the service door (see
Service door on page 41
).
Remove the memory module:
1.
Spread the retaining tabs
(1)
on each side of the memory module slot to release the memory
module. (The memory module tilts up.)
2.
Remove the memory module
(2)
by pulling the module away from the slot at an angle.
Reverse this procedure to install a memory module.
46
Chapter 5 Removal and replacement procedures for Customer Self-Repair parts
Summary of Contents for 210 G1
Page 4: ...iv Important Notice about Customer Self Repair Parts ...
Page 6: ...vi Safety warning notice ...
Page 10: ...x ...
