To remove the touchpad click board:
1.
Disconnect the touchpad cable (1) from the system board, and then disconnect from the touchpad click
board cable (2) touchpad.
2.
Remove the two Phillips M2.0 × 2.0 screws (3) that secure the touchpad click board to the computer.
3.
Lift the board, and then slide it outward from under the clips that hold it on place to remove it (4).
TIP:
The edge of the board sits under clips. Be sure to slide the board out from under the clips to
prevent damage to the board or clips.
Reverse this procedure to install the touchpad click board.
Touchpad
To remove the touchpad, use this procedure and illustration.
Table 5-12
Touchpad description and part number
Description
Spare part number
Touchpad
L24484-001
Before removing the touchpad, follow these steps:
1.
Prepare the computer for disassembly (
Preparation for disassembly on page 26
).
2.
Remove the rubber feet (see
).
3.
Remove the bottom cover (see
).
4.
Remove the battery (see
5.
Remove the touchpad click board (see
Touchpad click board on page 38
).
Component replacement procedures
39
Summary of Contents for 245 G8
Page 4: ...iv Safety warning notice ...
