Chapter 1
1- 3
HP 3000/9x9KS and HP 9000/K2x0/K4x0/Kx70/Kx80 Memory Upgrade Installation
Installation Procedure (HP 3000/9x9KS and HP 9000/K2x0/K4x0/Kx70/Kx80)
Installation Procedure (HP 3000/9x9KS and HP
9000/K2x0/K4x0/Kx70/Kx80)
Verifying the Current PDC Firmware
If you are planning to install 64MB, 128MB, 256MB, or 512 MB Memory Modules, you may need to
verify your system’s PDC firmware version to see if it supports that type of memory (see “OS
Requirements and Diagnostic Support for 64 MB and 256 MB Modules” on page A-1). If you need to
upgrade your PDC, see the section entitled "Obtaining the Correct Firmware Patch."
Using On-Line Diagnostics: (If on-line diagnostics are not present on your system, use the Boot
Console Handler procedure to verify the current version.)
1. At the system prompt, enter sysdiag.
2. At the sysdiag prompt, enter sysmap.
3. At the sysmap prompt, enter cpumap.
The output of cpumap will display the current PDC revision (See Table A-1, Appendix A).
Using the Boot Console Handler:
1. Log on as root, and enter reboot -r. This command will shut down the operating system and reboot
the system.
2. If AUTOBOOT is on, you will receive the following message:
Process is starting autoboot process.
To discontinue, press any key within 10 seconds.
3. At this point, press any key within 10 seconds to interrupt the booting process.
4. The Main Menu is displayed. A prompt will appear as
MAIN MENU: Enter command or menu>
5. Enter the command in.
Summary of Contents for 3000/939KS
Page 5: ...v ...
Page 8: ...vii Contents ...
Page 54: ...3 6 Chapter3 Power On and Verification Installation Verification ...