2-2
Chapter 2
HP 9000/K100 Memory Upgrade Installation
Installation Procedure (HP 9000/K100)
Electrostatic Discharge (ESD) Precautions
When performing the upgrade procedures in this guide, you must observe the following antistatic
precautions to prevent damage to memory boards and system components from electrostatic discharge.
An ESD kit (HP P/N A3024-80004) is supplied with your memory upgrade kit. This ESD kit contains
one wrist strap, one conductive sheet, and one anti-static foam pad.
•
Always wear a grounded wrist strap when working on or around the system, and when handling
printed circuit boards.
•
Treat all assemblies, components, and interface connections as static-sensitive.
•
Perform all removal and installation in a work area where potential static sources are minimized
(preferably an anti-static work station).
•
Avoid working in carpeted areas, and keep body movement to a minimum while removing and
installing boards to minimize buildup of static charge.
Required Tools
To perform the procedures in this guide, you will need the following tools:
•
One #10 Torx driver (preferred tool)
•
One small flat-blade screwdriver (if Torx driver is not available)
Installation Procedure (HP 9000/K100)
Checking Existing System Memory
Reboot the System
Summary of Contents for 3000/939KS
Page 5: ...v ...
Page 8: ...vii Contents ...
Page 54: ...3 6 Chapter3 Power On and Verification Installation Verification ...