Chapter 2
2- 7
HP 9000/K100 Memory Upgrade Installation
Installation Procedure (HP 9000/K100)
SIMM pairs must be installed in the slot sequence (0a+0b, then 1a+1b, and so on).
The largest-sized modules (SIMM pairs) are installed in the lower number slots, followed by
smaller-sized modules.
NOTE
To prevent damage to memory boards and system components from electrostatic
discharge, always wear a grounded wrist strap when working on or around the system,
and when handling printed circuit boards.
Removing SIMMs
After removing the Memory Bulkhead as previously described, the SIMMs can be removed. You may
find it necessary to remove existing SIMMs before installing the upgrade SIMMs. Remember that the
final configuration of all the SIMMs (existing plus upgrade) must conform to the memory configuration
rules described previously. To remove SIMMs, follow these guidelines:
Summary of Contents for 3000/939KS
Page 5: ...v ...
Page 8: ...vii Contents ...
Page 54: ...3 6 Chapter3 Power On and Verification Installation Verification ...