RTC battery
Description
Spare part number
For use only on computer models with WWAN compatibility
664994-001
For use only on computer models without WWAN compatibility
599516-001
Before removing the RTC battery, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
Battery on page 33
).
5.
Remove the service cover (see
WLAN module on page 38
).
Remove the RTC battery:
NOTE:
Steps 1 and 2 apply to computer models with WWAN capability. See step 3 for RTC battery
removal information on computer models without WLAN capability.
1.
Disconnect the RTC battery cable
(1)
from the system board.
2.
Remove the RTC battery
(2)
. (The RTC battery is attached to the system board with double-
sided tape.)
Reverse this procedure to install the RTC battery on a computer model with WWAN capability.
NOTE:
Step 3 applies to computer models without WLAN capability. See steps 1 and 2 for
RTC battery removal information on computer models with WWAN capability.
Component replacement procedures
43
