Removal and replacement procedures 68
You can replace the HEX units during operation.
The following tools are required for installation:
•
T-25 Torx driver
•
Adjustable wrench or pipe wrench
Removing the heat exchanger unit with ball valves
NOTE:
For this procedure, remove the fan unit seated directly behind the heat exchanger unit
you will remove.
1.
Remove the fan unit ("
Removing the fan unit
" on page
51
).
2.
Remove the air deflector plate ("
Removing the air deflector plate
" on page
33
).
NOTE:
The heat exchanger units are deep-seated within the MCS unit. To access the
connections described in the following steps, extend your arm inside the MCS unit until you
come in contact with the appropriate connectors.
3.
Disconnect the temperature sensor connector from the HEX unit.
Summary of Contents for 403349-003
Page 13: ...Customer self repair 13 ...
Page 14: ...Customer self repair 14 ...
Page 15: ...Customer self repair 15 ...
Page 16: ...Customer self repair 16 ...
