Removal and replacement procedures 78
Removing the HEX coupling
1.
Shut off the water flowing into the MCS unit. ("
Shutting off the water
" on page
25
)
2.
Remove the corresponding fan unit. ("
Removing the fan unit
" on page
51
)
3.
Remove the corresponding air deflector plate. ("
Removing the air deflector plate
" on page
33
)
4.
Disconnect the temperature sensor cable from the heat exchanger unit.
5.
Slide back the insulation on either the In or Out water hose.
6.
Using the water hose fitting wrench and the counter hold wrench, disconnect either the In or Out
water hose from the heat exchanger unit.
Summary of Contents for 403349-003
Page 13: ...Customer self repair 13 ...
Page 14: ...Customer self repair 14 ...
Page 15: ...Customer self repair 15 ...
Page 16: ...Customer self repair 16 ...
