Removal and replacement procedures 88
Operator display
The operator display is located on the front door of the MCS unit.
The following tools are required for installation:
•
8-mm socket
•
Small Flathead screwdriver
Removing the operator display
1.
Power down the MCS unit ("
Powering down the MCS unit
" on page
24
).
2.
Open the front MCS door.
3.
Using an 8 mm socket or wrench, remove the three nuts and external star washers securing the
operator display rear cover to the back of the front MCS door.
4.
Remove the operator display rear cover.
Summary of Contents for 403349-003
Page 13: ...Customer self repair 13 ...
Page 14: ...Customer self repair 14 ...
Page 15: ...Customer self repair 15 ...
Page 16: ...Customer self repair 16 ...
