5
Test the network connectivity between Device A and Device C. If they cannot reach each other, locate the
failed nodes in the network.
Figure 3
Network diagram
Configuration procedure
1.
Configure the IP addresses for devices as shown in
2.
Configure a static route on Device A.
<DeviceA> system-view
[DeviceA] ip route-static 0.0.0.0 0.0.0.0 1.1.1.2
[DeviceA] quit
3.
Use the
ping
command to test connectivity between Device A and Device C.
<DeviceA> ping 1.1.2.2
Ping 1.1.2.2(1.1.2.2): 56 -data bytes, press CTRL_C to break
Request time out
Request time out
Request time out
Request time out
Request time out
--- Ping statistics for 1.1.2.2 ---
5 packet(s) transmitted,0 packet(s) received,100.0% packet loss
The output shows that Device A and Device C cannot reach each other.
4.
Use the
tracert
command to identify failed nodes:
# Enable sending of ICMP timeout packets on Device B.
<DeviceB> system-view
[DeviceB] ip ttl-expires enable
# Enable sending of ICMP destination unreachable packets on Device C.
<DeviceC> system-view
[DeviceC] ip unreachables enable
# Execute the
tracert
command on Device A.
<DeviceA> tracert 1.1.2.2
traceroute to 1.1.2.2(1.1.2.2) 30 hops at most,40 bytes each packet, press CTRL_C to
break
1 1.1.1.2 (1.1.1.2) 1 ms 2 ms 1 ms
2 * * *
3 * * *
4 * * *
5
<DeviceA>
The output shows that Device A can reach Device B but cannot reach Device C, which indicates
that an error has occurred on the connection between Device B and Device C.
Device A
Device B
Device C
1.1.1.1/24
1.1.1.2/24
1.1.2.1/24
1.1.2.2/24
Summary of Contents for 5920
Page 86: ...76 XGE1 0 2 N A P2P Two 0 ...
