Front I/O, USB Assembly
The front I/O, USB assembly is mounted to the front of the chassis and is removed by pulling it away
from the chassis.
1.
Prepare the computer for disassembly (
Preparation for Disassembly on page 35
).
2.
Remove the computer access panel (
Computer Access Panel on page 43
).
3.
Remove the front bezel (
Front Bezel on page 44
).
4.
Disconnect the three cables from the following system board connectors:
●
Yellow connector labeled FRONT USB
●
Green connector labeled FRONT USB2
●
Blue connector labeled FRONT AUD
NOTE:
The blue FRONT AUD connector is not located near the other two connectors
used for the front I/O assembly. See the image below for its location.
5.
Remove the screw that secures the assembly to the front of the chassis
(1)
.
6.
Rotate the right side of the assembly away from the chassis, and then pull the assembly toward
the right and away from the chassis
(2)
while threading the wires through the slot between the
drive cage and chassis front and the hole in the front of the chassis.
Figure 6-47
Removing the front I/O, USB assembly
To reinstall the assembly, reverse the removal procedure.
Front I/O, USB Assembly
73