112
Chapter 3
A-Class System Service
A-Class Server I/O Card Removal and Replacement
Step 2. Shut down the operating system.
Step 3. Power down the system.
Step 4. Unplug the server.
NOTE
Cabinet-mounted servers must be removed from the cabinet before proceeding.
Step 5. Remove the top of the server by unscrewing the knurled captive screws on each side
of the rear of the server. Slide the top back, lift it off, and set it aside.
Card Load Order Rules
Card
Rule
Access Port (AP) card
Must go in the bottom slot.
One HSC card and one PCI card
HSC card must go in the bottom slot
All PCI or all HSC cards
Load order doesn’t matter.
Summary of Contents for 9000 A-180
