Chapter 5
Post Superdome System Installation Check
108
•
Inspect cabling. Check that all cables are installed, secured, and properly routed.
•
Inspect test points. Check that test leads are removed from the test points, and that the test points are
properly covered.
•
Clean up and dispose of debris. Remove all debris from the area, and dispose of it properly.
•
Perform final check. Inspect the area to ensure that all parts, tools, and other items used to install the
system are disposed of properly. Then, if you have not already done so, close and lock the doors.
•
Enter information in the Gold Book. When you complete the installation and cleanup, we recommend
that you make the appropriate notations in the Gold Book, which should have been shipped with the
system.
•
Obtain customer acceptance (if required). This includes thanking the customer for choosing
Hewlett-Packard.
Summary of Contents for 9000 Superdome
