Chapter 6
Troubleshooting and Installation-Related Tasks
Superdome 64 Way Fails to Boot
116
Superdome 64 Way Fails to Boot
Among the reasons the Superdome 64 Way may not boot is that the firmware versions in the two cabinets are
not identical.
To verify that the firmware for the cabinets is identical:
Step 1. From the Guardian Service Processor (GSP) Main Menu, enter
cm
.
Step 2. At the GSP Command Menu, enter
de
.
Step 3. Select the
s
option.
Step 4. Enter the cabinet number.
Be sure to keep track of the cabinet number you choose. Later you will choose the cabinet number
of the other cabinet in order to compare the firmware revision numbers.
The following screen appears:
Figure 6-2GSP de Command with s Option
Step 5. Note the PDC firmware revision number next to the PDC FW Revision field.
Step 6. Check the firmware revision number for the firmware in the other cabinet.
Step 7. Compare the numbers.
If the numbers are different, the firmware for one or both of the cabinets may have to be updated,
depending on the revision number of the most current firmware.
Summary of Contents for 9000 Superdome
