Appendix D
Connecting a CE Tool to the GSP Using the Customer LAN
163
1. Run Reflection 1 on your laptop.
2. Click on the Network radio button.
3. Select UNIX HOST with VT220 (Reflection 1).
4. Click Connect.
5. Enter the IP address for the GSP.
The factory default Customer LAN IP address for the GSP is 192.168.1.1. (The factory default
Private LAN address for the GSP is 15.99.111.100.) Use this address when installing a system
for the first time. After you login to the GSP, you can change this address by using the
instructions in “Setting the Private and Customer LAN Information on the GSP” on page 63.
If LAN communications is established, the LAN activity LEDs on the GSP illuminate. One is a
green light and the other is a blinking amber light.
Figure D-2LAN Activity LEDs
The GSP powers on and the GSP Login prompt appears (GSP:login).
60IN027A
9/12/00
GSP
Green LAN LED
Amber LAN LED
(Blinking)
L3-L1
L2-L3
L1-L2
L1-L2
L3-L1
L2-L3
Summary of Contents for 9000 Superdome
