Chapter 3
Preparing Superdome for Booting
Setting the Private and Customer LAN Information on the GSP
64
Step 2. The prompt will ask if you want to modify the LAN port 0; enter
y
.
The current Customer IP address is shown; then the following prompt appears: Do you want to
modify it? (Y/[N])
Step 3. Enter
y
.
Step 4. Enter the new IP address.
The customer should provide this address for LAN Port 0.
Step 5. Confirm the new address.
Step 6. Enter the GSP Network Name.
This is the host name for the customer LAN. You can use any name you like. The name can be as
many as 64 characters, and include alpha numerics, - (dash), _ (under bar), . (period), or a space. It
is recommended that the name be a derivative of the complex name. For example, Acme.com_GSP.
Step 7. Enter the LAN parameters for Subnet mask and Gateway address.
This information should come from the customer.
Step 8. At the prompt, Do you want to modify the configuration for Lan Port 1?, enter
y
.
Here you are setting the LAN parameters for the Private LAN port on the GSP.
Step 9. Enter the LAN parameters.
The name of the first private port attached to the SMS is priv-01 and its IP address is
192.168.2.11. If additional complexes are added at the customer site, a hub is required and the
second complex private port is called priv-02 with an IP address of 192.168.2.12, and so on.
Step 10. To check the LAN parameters and status, enter the
ls
command at the GSP Command Menu
prompt (GSP:CM>).
A screen similar to the following appears:
Figure 3-27The ls Command Screen
Summary of Contents for 9000 Superdome
