Appendix A
hp Server rx2600 Support Management Station
Configuring the SMS
144
Configuring the Operating System
Perform the following to configure HP-UX 11i-v2:
Step 1. From the EFI boot manager menu, boot the operating system by selecting
HP-UX Primary Boot
at
the EFI menu.
When the system boots to
set_parms
, the following menu appears.
Figure A-17
set_parms
Menu
Step 2. Set the root password.
The default password
serialbus
.
Step 3. Enter the following data when prompted.
•
IP addresses
•
Host name
•
Global network mask
•
Gateway router IP address
Step 4. Using the
bdf
command, verify that these parameters are set as follows:
•
/tmp = 1000 MB
•
/opt = 6900 MB
Step 5. Verify that the DVD and DAT drives are configured as per the documentation sent with the system
or set to default (DVD = 1, DAT = 3). Enter the following at the prompt:
#
ioscan -fn
Step 6. If the DAT drive is not claimed by the operating system, enable it by entering
kcmodule
stape=static
, to reboot the SMS.
Summary of Contents for 9000 Superdome
