99
To do…
Use the command…
Remarks
Enter system view
system-view
—
Configure the exception
handling method
system-failure
{
maintain
|
reboot
}
Optional
By default, the system adopts the
reboot
method to handle exceptions.
Rebooting the firewall
Rebooting the firewall in the web interface
Select
Device Management
>
Reboot
from the navigation tree to enter the page, as shown in
.
Figure 65
Device reboot configuration page
Click
Apply
to reboot the device.
If you select
Check whether the configuration is saved to the configuration file for next boot
, the device
will do the related checking before rebooting. If finding that the current configuration is not saved in the
configuration file to be used at next boot, the system will prompt that the device cannot reboot.
Device reboot configuration example
1.
Network requirements
The IP address and mask of the interface on Device A and those of Host A are shown in
. It is
required to reboot Device A through the Web interface on Host A.
Figure 66
Network diagram for device reboot
2.
Configuration procedure
# Select device reboot on Host A.
•
Select
Device Management
>
Reboot
from the navigation tree.
•
Click
Apply
to reboot the device.
•
Wait until the reboot result page appears.
•
Click
Relogin
to log in to the Web interface again.
Rebooting the firewall in the CLI
When a fault occurs to a running firewall, you can remove the fault by rebooting the firewall with one of
the following methods:
