73
Logging in to the firewall module from the
network device
NOTE:
This chapter describes how to log in to the firewall module from the network device. Other login methods
for the firewall module are the same as a firewall. For more information, see the previous chapters.
Logging in to the firewall module from the network
device
Configuring the AUX user interface of the firewall module
Before logging in to the firewall module from the network device, you need to configure the AUX user
interface of the firewall module.
Follow these steps to configure the AUX user interface:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter AUX user interface view
user-interface aux
first-number
[
last-number
]
—
Specify the none authentication
mode
authentication
-
mode none
Required
By default, the AUX user interface
uses password authentication.
Configure the user privilege level
user privilege level
level
Required
0 by default. HP recommends you
to set it to 3.
Logging in to the firewall module
Use the following command to log in to the firewall module. After login, the terminal screen displays the
CLI of the firewall module. To return to the CLI on the device, press
Ctrl+K
.
Follow the step below to log in from the network device to the firewall module:
To do…
Use the command…
Remarks
Log in from the network device to
the firewall module
oap connect
slot
slot-number
Required
Available in user view of the network
device (switch or router)