2-8
Chapter 2
Unpacking and Installation
PowerTrust UPS Option
PowerTrust UPS Option
Unpack the PowerTrust UPS and read all the installation information in the PowerTrust
System Guide part number 5961-8383. Once all the procedures listed in the UPS guide are
complete, perform the following steps to complete the UPS installation with the cabinet.
1. Position the UPS next to the cabinet on the floor.
2. Remove the jumper cord form the SPU to the PDU inside the cabinet.
3. Install one of the convenience cords (output cord) that came with the UPS into the AC
receptacle in the back of the SPU.
4. Place the other end of that cord into one of the Output outlets in the back of the UPS.
5. The other convenience cord is connected between the UPS and the system console.
6. Locate the appropriate input line cord for the UPS in the supplemental package
shipped with the UPS.
7. Plug the UPS into the appropriate wall outlet.
8. The system should now be ready for power up.
Summary of Contents for A3764A
