Item
Specification
Memory type and size
DDR2 SDRAM
1 GB (default, one 1 GB memory module)
2 GB (maximum)
NVRAM
128 KB
Combo interfaces
2
2 electrical interfaces
(automatic MDI/MDIX)
10 Mbps, half/full-duplex
100 Mbps, half/full-duplex
1000 Mbps, full-duplex
2 optical interfaces
1000 Mbps, full-duplex
HIM
Not supported
MIM
4 MIMs supported at the same time
Dimensions (H × W × D)
45 × 399 × 412 mm (1.77 × 15.71 × 16.22 in.)
Hardware encryption
Supported
Power consumption
50 W
hot-swapping
Supported
For a Combo interface, the default operating interface is the electrical interface.
For a Combo interface, you can use either the electrical Ethernet interface or the optical
Ethernet interface. You can use the
combo enable
{
copper
|
fiber
} command in interface
view to switch between the optical and electrical interfaces. For details about the
combo
enable
{
copper
|
fiber
} command, refer to
Ethernet Interfaces
in the
Access Volume
of
HP
SR6600 Routers User Manual
.
Use optical transceivers provided by HP only. The device may be incompatible with other
optical transceivers and thus displays alarms automatically.
"Hot-swapping" a module refers to first using the
remove slot
slot-number
command to stop
the module, and then manually pulling it out, or inserting the module into its slot without
powering off the device. For details about the
remove slot
command, refer to
Device
Management
in the
System Volume
of
HP SR6600 Routers User Manual
.
LEDs
Figure 1-15
FIP-100 LEDs
(1) LED for 10/100/1000 Mbps electrical Ethernet interface 0 (GE0)
(2) LED for 10/100/1000 Mbps electrical Ethernet interface 1 (GE1)
(3) 1000 Mbps optical Ethernet interface LED (SFP0)
Summary of Contents for A6616
Page 1: ...HP A6616 Router Installation Manual ...
Page 47: ......
