5
Figure 5
Install/remove a 300W AC power supply
Installing a power supply
Follow these steps to install a power supply:
Step1
Wear an ESD-preventive wrist strap and make sure it makes good skin contact
and is well grounded.
Step2
Remove the blank filler (if any) from the slot to be used. Keep the blank filler
properly for future use.
Step3
Unpack the power supply, and check that the power supply model is correct.
Step4
Be sure to insert the power supply with the right side up. Grasp the handle of the
module with one hand and support the module bottom with the other.
Step5
Gently push the power supply along the guide rails into the slot until it has firm
contact with the backplane.
CAUTION:
To prevent damage to the power supply and the connection terminals on the
backplane, be sure to pull out the power supply first in case of any misalignment, and
then push it in again.
Step6
Use a No. 2 Phillips screwdriver to fasten the captive screws on the power supply
to secure the power supply into the chassis.
CAUTION:
If the captive screws cannot be fastened, check that the power supply is properly
installed.
