1.
Shut down the system and remove the top cover as explained in Section 4.2.
2.
Remove the slot cover screw
X
; remove the slot cover
Y
by sliding it out of the
enclosure.
3.
Slide the PCI option module
Z
into the first available slot and plug it into the PCI
riser
[
.
4.
Insert the screw
n
to secure the module.
5.
Replace the top cover and reassemble the system enclosure as explained at the end of
Section 4.2.
6.
Turn on system power by pressing the power switch on the operator control panel. Boot
the operating system.
Verification
1.
Turn on power to the system.
2.
At the >>> prompt, enter the SRM
show config
command. Examine the PCI bus
information in the display to make sure that the new option is listed.
3.
If you installed a bootable device, enter the SRM
show device
command to determine
the device name.
See Chapter 1, the section on
PCI Slots
,
for more information about PCI slots.
Installing and Configuring Options
4-31