Example
>>> set eia0_mode twisted-pair
Changing to selected mode.
>>> show eia0_mode
eia0_mode Twisted-Pair
The options for eg*_mode
value
are:
Auto
Auto negotiation*
10mbps
10 Mb half duplex
10mbps_full_duplex
10 Mb full duplex
100mbps
100 Mb half duplex
100mbps_full_duplex
100 Mb full duplex
1000mbps
1000 Mb half duplex
1000mbps_full_duplex
1000 Mb full duplex
* If no Ethernet cable is connected in this mode, the SRM reports a failure:
Error (eib0.0.10.0), No link, auto negotiation did not complete. This is applicable for ei*,
ew*, and eg* device in auto negotiate.
Using Firmware
5-45