To set the RMC-related system jumpers to their default settings, configure as follows (see
Figure 6–5 for locations):
•
Feature_1 Jumper / J22 pins 13 – 14
On – OCP halt/reset button performs reset
Off – OCP halt/reset button performs halt
(default)
•
Feature_2 Jumper /J22 pins 11 – 12
On – Forces RMC emergency image recovery mode
Off – Normal operation
(default)
•
Feature_4 Jumper / J22 pins 3-4
On – indicates disk cage fan speed is not monitored (this setting is used when the
system contains an Internal Access Storage Cage).
Off – indicates disk cage fan speed is monitored (this setting is used when the system
contains a Front Access Storage Cage).
•
RMC_PASSTHRU Mode Jumper / J30
No jumper – Always bypass the RMC
1 – 2 Always pass through the RMC
2 – 3 Normal operation
(default)
Note:
The user selects modes through COM1_MODE.
•
RMC Force_Default Jumper / J22 pins 9 – 10
On – Forces RMC environment to default state
Off – Normal operation
(default)
•
FORCE_DTR Jumper / J28
On – Forces DTR
Off – DTR unaffected
(default)
•
Booter_enable Jumper / J22 pins 7-8
On – Allows RMC booter image updates
Off – Disables RMC booter image updates (
default
)
6-34
hp AlphaServer TS15 Owner’s Guide
