7.4
Console-Reported Failures
Table 7–5 Troubleshooting Console-Reported Failures
Symptom
Action
Power-up tests do not complete.
Use error beep codes or console serial terminal to
determine what error occurred.
Check the power-up screen for error messages.
Enter the RMC and use the
poe
command to check for
poweron errors; use the
log #
command to check
the event log for symptoms of failure.
Console program reports an
error.
Interpret the error beep codes at power-up and check
the power-up screen for a failure detected during self-
tests.
Examine the console event log (use the
more el
command) to check for embedded error messages
recorded during power-up.
If the power-up screen or console event log indicates
problems with mass storage devices or PCI devices, or
if devices are missing from the
show config
display,
see Section 7.10.
Enter the RMC and use the
poe
command to check for
poweron errors; use the
log
or
log #
command to check
the event log for symptoms of failure.
Use the SRM
test
command to verify the problem.
7-6
hp AlphaServer TS15 Owner's Guide
