Memory Testing and Configuration Status
Array Size Base Address Intlv Mode
--------- ---------- ---------------- ----------
0 512Mb 0000000040000000 1-Way
2 1024Mb 0000000000000000 1-Way
1536 MB of System Memory
Testing the System
Testing the Disks (read only)
Testing the Network
AlphaServer TS15 Console V6.3-1, built on Jun 10 2003 at
11:51:30
>>>
Explanation
The CPU prints a message indicating that it is running the console. Starting with this
message, the power-up display is sent to any console terminal, regardless of the state
of the
console
environment variable.
If console is set to
graphics
, the display from this point on is saved in a memory
buffer and displayed on the VGA monitor after the PCI buses are sized and the VGA
device is initialized.
The memory size is determined and memory is tested. Memory testing is based on
the “memory_test” environment variable – none, partial, full.
The I/O subsystem is probed and I/O devices are reported. I/O adapters are
configured.
Device drivers are started.
Various diagnostics are performed. Diagnostic testing is based on the
“full_powerup_diags” environment variable – On/Off
The console terminal displays the SRM console banner and the prompt, >>>.
2-6
hp AlphaServer TS15 Owner's Guide
