39
3 Upgrading and Adding Accessories
Upgrading Hardware
Upgrading Hardware
Removing and Replacing the Cover
You need to remove the computer’s cover to install accessories or to gain access to the system configuration jumpers.
Removing the Cover
1
Turn off the computer and display, and disconnect all power supply cords and any telecommunications cables.
2
If necessary, unlock the cover using the key on the back panel. Remove the four screws from the back of the computer.
3
Pull the cover back 1.5 cm, then lift the cover completely off the computer’s chassis.
Warning
For your safety, never remove the computer’s cover without first removing the power cord and any connection to a
telecommunications network. Always replace the cover before reconnecting any cables to your computer.
1.5 cm
❶
❷
❸
On some computers the screw positions may be higher then shown
Summary of Contents for Brio 8300
