61
3 Upgrading and Adding Accessories
Adding Accessories
Installing a Floppy Disk Drive, CD-ROM Drive, Zip Drive, or Tape Drive
1
To remove the front bezel, move the computer to the edge of the table (only far enough to be able to place your hand
between the table and the front bezel). Pull the front bezel outwards from the computer by hooking your fingers in the
gap and pulling (it should still be connected at the top). Then, gently continue to pull the front bezel outwards until it
is completely detached from the computer.
2
Check that there are no mounting rails attached to the device. If there are mounting rails attached, you should remove
them.
Table edge
To remove the plastic panel from
the bezel, unclip and push
outwards. Store the panel in a safe
place.
View from inside the bezel
Hook your fingers in the gap
underneath the bezel and
pull out
Summary of Contents for Brio 8300
