70
Appendix AT Commands
Basic AT Commands
AT&C
n
Selects data compression for MNP or V.42, where
n is a digit from 0 to 3. For data compression to work, both
the local and the remote modem must have compression capabilities. The
n parameters are:
0
-
Compression is not authorized.
1
-
Auto enable/disable.
2
-
Data compression enabled.
3
-
MNP5 compression disabled.
AT&D
n
This command controls the way that your modem responds to the Data Terminal Ready (DTR) signal:
0
-
Ignores DTR signal.
1-
Modem interprets an ON-to-OFF transition as escape characters and moves to Command Mode, while
keeping data connection.
2
-
An ON-to-OFF DTR transition causes the modem to hang up and disables auto-answer.
3
-
An ON-to-OFF DTR transition resets the modem to hang up and disables auto-answer.
AT&F
Modem returns to factory default settings.
AT&K
n
This command controls the flow control:
0
-
Disables flow control.
1
-
Enables RTS/CTS (hardware) flow control (default).
2
-
Enables XON/XOFF (software) flow control.
Command
Description
Summary of Contents for Brio 8300
