B Electrostatic discharge
This appendix provides the following information:
• How to prevent electrostatic discharge
, page 47
• Grounding methods
, page 47
How to prevent electrostatic discharge
To prevent damage to the system, you must follow certain precautions when setting up the system or
handling parts. A discharge of static electricity from a
fi
nger or other conductor may damage system
boards or other static-sensitive devices. This type of damage may reduce the life expectancy of the device.
To prevent electrostatic damage, observe the following precautions:
•
Avoid hand contact by transporting and storing products in static-safe containers.
•
Keep electrostatic-sensitive parts in their containers until they arrive at static-free workstations.
•
Place parts on a grounded surface before removing them from their containers.
•
Avoid touching pins, leads, or circuitry.
•
Always make sure you are properly grounded when touching a static-sensitive component or
assembly.
Grounding methods
There are several methods for grounding. Use one or more of the following methods when handling or
installing electrostatic-sensitive parts:
•
Use a wrist strap connected by a ground cord to a grounded workstation or chassis. Wrist straps
are
fl
exible straps with a minimum of 1 megohm ± 10 percent resistance in the ground cords. To
provide proper ground, wear the strap snug against the skin.
•
Use heel straps, toe straps, or boot straps at standing workstations. Wear the straps on both feet
when standing on conductive
fl
oors or static-dissipating
fl
oor mats.
•
Use conductive
fi
eld service tools.
•
Use a portable
fi
eld service kit with a folding static-dissipating work mat.
If you do not have any of the suggested equipment for proper grounding, have an HP authorized
reseller install the part.
NOTE:
For more information on static electricity, or for assistance with product installation, contact your
HP authorized reseller.
Brocade 8Gb SAN Switch for HP BladeSystem c-Class
47
Summary of Contents for Brocade 8Gb SAN
