2
HP Part Number 5990-3463
Installing the Plastic Rails (Models DAT 24i and DAT 40i)
The plastic drive rails are secured to the drive by spring tension.
To install the plastic drive rails:
1. Insert one end of the wire rod on the rail into the mounting hole at the rear of the drive (
Figure 2
).
2. Apply pressure to the middle of the rail allowing the remaining wire rod end to be inserted into the mounting hole at
the front of the drive. Ensure that the rail is seated against the side of the drive.
3. Repeat the installation for the second mounting rail.
Figure 2. Plastic Drive Rails
HP Server tc4100 Configuration
The HP Server tc4100 can accept any of the following HP Surestore tape drives:
Figure 1. HP Surestore Supported Locations for the HP Server tc3100
NOTE
In any of these server configurations, the CD-ROM is normally mounted in location
P1 in the pedestal configuration and in location R3 in the rack mount configuration
(see
Figure 3
).
Pedestal
Shelf Mount
P2 Location
R2 Location
Wire Rod Ends
Mounting Holes
Wire Rod
Insert this wire
rod end last
Apply pressure
to middle of rail
Insert this wire rod
end first
