NOTE:
If the WWAN antenna is not connected to the terminal on the WWAN module, a protective sleeve
must be installed on the antenna connector, as shown in the following illustration.
Reverse this procedure to install the WWAN module.
Connector board
NOTE:
The connector board spare part kit includes the cable.
Description
Spare part number
For use only on computer models equipped with WWAN capability (includes SD Card Reader slot and
SIM slot)
785884-001
For use only on computer models not equipped with WWAN capability (includes SD Card Reader slot)
783087-001
Before removing the connector board, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4.
Remove the keyboard/top cover (see
Keyboard/top cover on page 25
).
5.
Remove the WWAN module (see
WWAN module on page 34
).
Remove the connector board:
1.
Release the ZIF connector (1) to which the connector board cable is attached, and then disconnect the
connector board cable from the system board.
2.
Remove the two Philllips PM1.9×4.2 screws (2) that secure the connector board to the base enclosure.
Component replacement procedures
35
Summary of Contents for Chromebook 11 G3
Page 4: ...iv Safety warning notice ...
