Display assembly
Description
Spare part number
15.4-inch, WXGA, BrightView display assembly (includes wireless antenna transceivers
and cables)
444896–002
Before removing the display assembly, follow these steps:
1
.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2
.
Disconnect all external devices connected to the computer.
3
.
Disconnect the power cord.
4
.
Remove the battery (see
Battery on page 29
).
5
.
Remove the memory module compartment cover (see
Memory module on page 32
).
6
.
Disconnect the wireless antenna cables from the WLAN module (see
WLAN module on page 35
).
7
.
Remove the following components:
a
.
Switch cover (see
Switch cover on page 38
)
b
.
Keyboard (see
Keyboard on page 40
)
Remove the display assembly:
1
.
Disconnect the display cable
(1)
from the system board.
2
.
Remove the wireless antenna cables
(2)
from the clips built into the top cover.
CAUTION:
Support the display assembly when removing the following screws. Failure to support
the display assembly can result in damage to the display assembly and other computer components.
3
.
Remove the four Phillips PM2.5×7.0 screws
(1)
that secure the display assembly to the computer.
44 Chapter
4
Removal and replacement procedures
