8-3
Compaq Professional Workstation SP700 Reference Guide
Writer: kmosby Project: Compaq Professional Workstation SP700 Reference Guide Comments: 320280-002
File Name: I-CH08.DOC Last Saved On: 12/16/98 2:53 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Removing a Blank Drive Bezel
A blank drive bezel covers bays 5 and 6 when they are not occupied with a
storage device. You will need to remove a drive bezel before installing any
removable media storage device (example: tape drive, CD-ROM or DVD-
ROM, and diskette) in these bay locations. You will not need to replace the
drive bezel after the drive installation.
To remove a blank drive bezel:
1. Turn off the workstation and disconnect the power cord from the
grounded AC outlet and the back of the workstation.
2. Remove the side access panel.
3. Refer to the following illustration to remove a blank drive bezel.
Figure 8-2. Removing a blank drive bezel