8-6
Drives
Writer: kmosby Project: Compaq Professional Workstation SP700 Reference Guide Comments: 320280-002
File Name: I-CH08.DOC Last Saved On: 12/16/98 2:53 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Installing a 7200 rpm Hard Drive in
Bays 5 or 6
Drive bays 5 and 6 can be configured with either 1.0-inch or 1.6-inch 7200 rpm
hard drive. Other than using different screw holes, the installation for both
drives is basically the same. To install a 7200 rpm hard drive:
NOTE
: Before installing a SCSI device, please read “SCSI Cables and
Guidelines” later in this chapter.
1. Turn off the workstation and disconnect the power cord from the
grounded AC outlet and the back of the workstation.
2. Remove the following components:
❏
side access panel
❏
front bezel
❏
cooling shield
3. Refer to the following illustrations to install a 7200 rpm hard drive in
bays 5 or 6.
Figure 8-5. Installing a 7200 rpm hard drive in the hard drive bracket