Removal and replacement procedures 34
13.
Push in to release the four locking mechanisms on the rails located on the side and bottom of the drawer.
14.
Remove the hard drive drawer.
To replace the component:
1.
Slide the rails back into the chassis.
2.
Align the top right edge of the drawer with the flange at the top of the chassis and align the four rails
on the left side and bottom of the drawer bay.
CAUTION:
To avoid damage to the equipment, HP recommends using two people to perform
this step.
Summary of Contents for D6000 Disk Enclosure
Page 12: ...Customer self repair 12 ...
Page 13: ...Customer self repair 13 ...
Page 14: ...Customer self repair 14 ...
Page 18: ...Illustrated parts catalog 18 ...