Creating Labels Using Internal Batach Software
DMX 400/430 Operator’s Manual
49
3.4 Print Label Screen
The print label screen is used to print labels that have been
formatted and/or modified in the create/modify label screen. From
the create/modify label screen, press the F1 key to toggle to the
print label screen . The screen should look like this:
PRINT LABEL
MODULE NAME: ______________
LABEL NAME: ________________
QUANTITY: _______________
Figure 3-5 Print Label Screen
3.4.1 Printing a label from the ‘Print Label Screen ’
1.
Enter the label name you want to print and press the return key.
The cursor will move to the quantity position. If the Printer does
not find the label name you entered, you will receive an error
message and will need to re-enter the label name. When in the
label name position, you can use the F2 key (LIST) to list all of
the names available in the currently installed memory module.
2.
Enter a number, not more than four digits long, to indicate the
quantity of labels you wish to print and press the return key.
The maximum number of labels per run is 9999.
3.
Depending on how the label is set up, the cursor may move to
the initial increment or initial decrement position if a
consecutive number or letter was specified as a data type. Or,
the cursor may move to a prompting position if a P was
specified as a data type. Enter the starting number or the prompt
information, followed by the return key, for each consecutive
number or prompt. After this information is entered, the cursor
will move to the sample position.
Summary of Contents for DMX 400
