Chapter 4
Verification Tests
Introduction
Three test procedures are given in this chapter. These test procedures are
used to verify that:
•
the HP E1418A is functional
(Functional Verification)
•
the HP E1418A meets selected testable specifications
(Quick Verification)
•
the HP E1418A meets all testable specifications
(Performance Verification)
WARNING
Do not perform any of the following verification tests unless
you are a qualified, service-trained technician and have read
the WARNINGS and CAUTIONS in Chapter 1 of this manual.
Test Conditions
Table 1-1, on page 14, lists the recommended test equipment. When
performing the test procedures, observe the following test conditions:
•
The ambient temperature should be between 18
°
C and 28
°
C.
The temperature should be stable within
±
1
°
C.
•
The relative humidity should be < 65%, non-condensing.
•
Install the module, apply power, and allow the module to warm up
for at least 15 minutes.
Hewlett-Packard recommends performance tests be performed at one year
intervals. In severe operating environments, or after heavy use, perform the
tests more often.
Chapter 4
Verification Tests 29]
Summary of Contents for E1418A
