HP E1586A Rack Mount Terminal Panel
11
Configuration for
HP E1413/E1415
with Digital I/O
SCPs
This configuration should be used for the HP E1413/E1415 Digital I/O
Signal Conditioning Plug-on (SCP). This especially the case when low level
analog SCPs are used with the digital I/O SCP. This configuration may make
it necessary to connect the digital channels through the E1586 Option 001
board. To configure the Terminal Panel, when using a digital I/O SCP, move
the jumpers for each affected channel as shown in Figure 7 on page 12
Figure 6. Option 001 Two-Wire Cable Configuration
RC Filters Placed Into the Signal Path and
Common-mode Transformer Enabled
Summary of Contents for E1586A
Page 2: ...2 Contents ...
