Rear-facing webcam
NOTE:
The rear-facing webcam is included in the Webcam Kit, spare part number 793724-001.
The rear-facing webcam spare part kit does not include the rear-facing webcam cable. The rear-facing
webcam cable is included in the Slate Cable Kit, spare part number 793721-001.
Before removing the rear-facing webcam, follow these steps:
1.
Shut down the slate. If you are unsure whether the slate is off or in Hibernation, turn the slate on, and
then shut it down through the operating system.
2.
Disconnect all external devices connected to the slate.
3.
Disconnect the power from the slate by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the slate.
4.
Remove the display panel assembly (see
Display panel assembly on page 35
), and then remove
the following components:
a.
Battery (see
Battery on page 39
)
b.
WLAN module (see
WLAN module on page 40
)
c.
WWAN module (see
WWAN module on page 42
)
d.
Fan (see
Fan on page 46
)
e.
System board (see
System board on page 52
)
Remove the rear-facing webcam:
1.
Turn the system board upside down with the top edge toward you.
2.
Disconnect the rear-facing webcam cable (1) from the front-facing webcam board.
3.
Remove the rear-facing webcam (2).
Reverse this procedure to install the rear-facing webcam.
64
Chapter 5 Removal and replacement procedures – slate
