Reverse this procedure to install the WLAN antenna.
WiGig antenna
Description
Spare part number
WiGig antenna (includes WiGig antenna cable and transceiver)
805066-001
Before removing the WiGig antenna, follow these steps:
1.
Shut down the slate. If you are unsure whether the slate is off or in Hibernation, turn the slate on, and
then shut it down through the operating system.
2.
Disconnect all external devices connected to the slate.
3.
Disconnect the power from the slate by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the slate.
4.
Remove the display panel assembly (see
Display panel assembly on page 35
), and then remove
the following components:
a.
Battery (see
Battery on page 39
)
b.
WLAN module (see
WLAN module on page 40
)
c.
WWAN module (see
WWAN module on page 42
)
d.
Fan (see
Fan on page 46
)
e.
System board (see
System board on page 52
)
Remove the WiGig antenna:
1.
Detach the WiGig antenna transceiver (1) from the bottom cover. (The WiGig antenna transceiver is
attached to the bottom cover with double-sided adhesive.)
2.
Release the WiGig antenna cable from the retention tabs (2) built into the bottom cover.
WiGig antenna
71
