3.
Remove the WWAN antennas (1) and WLAN antennas (2) (if equipped) from the routing path along the
base of the computer.
4.
Remove the 4 Phillips PM2.5×5.0 screws (1) from the display hinges.
5.
Lift the hinges (2) up and remove the top cover from the display assembly (3).
CAUTION:
When installing the display assembly, be sure that the wireless antenna cables are routed
and arranged properly.
Failure to properly route the antennas can result in degradation of the computer's wireless performance.
6.
If you need to remove the display bezel, flex the top (1) of the bezel, the inside edges of the left and
right sides (2), and then the bottom (3) of the bezel until it disengages from the display enclosure.
NOTE:
Make sure the hinges are not bent (see hinge position in following image) when you remove the
bezel.
62
Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
