Display assembly
NOTE:
The display assembly is spared at the subcomponent level only. For more display assembly
spare part information, see the individual removal subsections.
Before removing the display assembly, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the service cover (see
Service cover on page 42
), and then remove the following
components:
a.
Battery (see
Battery on page 44
)
b.
Hard drive (see
Hard drive on page 46
)
c.
Keyboard (see
Keyboard on page 56
)
d.
Top cover (see
Top cover on page 63
)
Remove the display assembly:
1.
Release the display panel cable from the routing clips
(1)
and channel built into the
base enclosure.
2.
Release the wireless antenna cables from the routing clips
(2)
and channel built into the
base enclosure.
Component replacement procedures
67
Summary of Contents for EliteBook 820 G1
Page 4: ...iv Safety warning notice ...
Page 26: ...Computer major components 18 Chapter 3 Illustrated parts catalog ...
Page 146: ......
