2.
Spread the two retention clips outward (1) until the memory module tilts up at a 45° angle, and then
remove the module (2). Use the same procedure to remove all memory modules.
IMPORTANT:
To prevent damage to the memory module, hold the memory module by the edges only.
Do not touch the components on the memory module.
To protect a memory module after removal, place it in an electrostatic-safe container.
To install a memory module:
1.
Align the notched edge of the module with the tab in the slot (1), and then press the module into the slot
at an angle until it is seated (2).
2.
Press down on the module until the side retention clips snap into place (3).
36
Chapter 5 Removal and replacement procedures for Customer Self-Repair parts
Summary of Contents for EliteBook 835 G7
Page 4: ...iv Important notice about Customer Self Repair parts ...
Page 6: ...vi Safety warning notice ...
Page 10: ...x ...
