4.
If the WWAN antenna is not connected to the terminal on the WWAN module, a protective sleeve must be
installed on the antenna connector, as shown in the following illustration.
Reverse this procedure to install the WWAN module.
Solid-state drive
To remove the M.2 solid-state drive, use this procedure and illustration.
Table 5-5
Solid-state drive descriptions and part numbers
Description
Spare part number
1 TB, PCIe, TLC
L85348-002
512 GB, PCIe, TLC
L85360-002
512 GB, PCIe, TLC, self-encrypting drive (SED)
L85368-002
512 GB, PCIe, value
L85364-002
256 GB, PCIe, TLC
L85350-002
256 GB, PCIe, TLC, self-encrypting drive (SED)
M07245-002
256 GB, PCIe, value
L85354-002
128 GB, SATA-3, TLC
L85346-002
Solid-state drive cover (included in Bracket Kit)
M08556-001
Before removing the solid-state drive, follow these steps:
1.
Prepare the computer for disassembly (
Preparation for disassembly on page 33
2.
Remove the bottom cover (
).
3.
Disconnect the battery cable from the system board (see
).
Remove the solid-state drive:
40
Chapter 5 Removal and replacement procedures for Customer Self-Repair parts
Summary of Contents for EliteBook 835 G7
Page 4: ...iv Important notice about Customer Self Repair parts ...
Page 6: ...vi Safety warning notice ...
Page 10: ...x ...
